Z Auto 2018+ Jeep Wrangler JL & Gladiator JT Tazer MINI Programmer, FedEx 2 Day

Description

The Z Automotive Tazer MINI is an essential tool for 2018+ Wrangler JL, JLU, and 2020+ Gladiator owners!  The MINI gives you all of the essentials with a simple plug and play programmer in a one piece design that plugs into the OBD2 port. See the list below for a full list of features!
These are all accessed using the factory dash display using the steering wheel buttons to navigate the menus.
Perf Menu:
Adjust for alternate tire sizes up to 41''
Adjust for alternate axle gear ratios
Adjust for an alternate transfer case LO range ratio
TPMS Menu:
Disable TPMS system if desired
Change front/rear TPMS warning PSI limit
Radio Menu:
Disable Backup camera
Enable Cargo Camera input
Enable CD audio input
Disable TravelLink (weather warnings included)
Lighting Menu
Change DRL region (type)
Change DRL location
Disable DRL Dropout
Enable Fog lamp output
Disable Fog lamp dropout
Disable Halo’s
Set LED 3rd brake light type
Set LED tail lamp type
Set LED front turn signal type
Set Trailer Tow output for use with Mopar kit
Other Menu:
Disable/Enable Electronic sway bar – for axle swaps or to run disconnected at any speed or drive mode
Disable/Enable Front Axle Disconnect
Disable/Enable Front and Rear Lockers
Enable Aux switch settings on the radio
Enable Blind spot detection (sensors required)
Change cluster splash screen to Wrangler/Sahara/Rubicon
Enable/Disable PANIC button on remote
Live features - these run only while the tazer is plugged in:
Light shows: Can be accessed from the key fob or from the on-screen menu. 6 pre-set light shows and 3 make-your-own shows included. Set from the factory to only operate when parked, but can be unlocked for off-road and emergency personnel use.
Disable Navigation in-motion lockout - enter addresses while the vehicle is moving
Disable camera lockout – use the backup camera and/or added cargo/front/undercarriage camera at any speed for any length of time
Auto Traction Kill - can be set to turn off traction control upon start-up
Auto StopStart Disable - can be set to disable AutoStopStart upon vehicle start-up 0-30 and 0-60 timers
AutoPark Disable – can override the AutoPark system
TurnCAM – can turn on backup camera whenever turn signals are used (great for when the doors are off) 0-30 and 0-60 timers
Cooldown mode - run engine fans when Jeep is off, to aid in cooldown
Winch mode – raise engine idle to 2000 RPM while winching or jumping another vehicle Clear Check engine light
Free USB updates - certainly more to come!
Tazer Mini Part # TAZERJL-Mini
This device is a PROGRAMMER and not a taser that can shock you. Due to Ebay continually removing our listing for this PROGRAMMER, we must mention that we "will not" allow buyers to purchase this PROGRAMMER where tasers are illegal.