-40%
Monster Mill MM3 three roller grain mill
$ 52.8
- Description
- Size Guide
Description
Monster Mill MM3 three roller grain mill.This mill is well used but is ready for a lot more use. I’d say it’s perfectly broken in. I bought it new and I’m sad to see it go. At last use I was getting the ideal crush for an efficient mash. I’m including the feeler gauge I used to set the gap to usually .045 (though it’s well worn so I’d recommend buying a new one). There is general use wear and tear but nothing that compromises function. I’d estimate this mill has milled about 300-400 pounds of grain in its time so far.
Here is the manufacturers description…
The MM-3 consists of a 6061 aluminum block frame with three 6" long steel rollers riding on SAE 841 oil impregnated bronze bushings. We use a superior grade of steel that is much harder than what is found on most comparable products and should last almost twice as long. The drive shaft, and all the axles are integral to the roller rather than screwed into the ends. This makes it fine to drive the mill clockwise, or counter-clockwise. All the axles are 3/8", with minimal freeplay in the bushings.
One knurled steel roller is driven by a standard electric drill (not included) to feed the grain through the initial fixed gap of approximately .060", and then through the adjustable secondary gap and crush the grist. Both ends of the non-driven top idler roller ride in bronze bushings that are pressed into the frames, while the second idler roller rides in bushings that are offset mounted in an adjustable knob. The knob is held in a fixed position by a set-screw that you can loosen to adjust the mill. This system provides an adjustment range of .065". The knobs are made from 303 stainless steel for excellent durability, and are larger in diameter than the competition, as well as knurled for a positive grip. They've also added a groove in our newest design knobs with a matching rounded head on the thumbscrew that allows for a much better grip on the knob to avoid gap changes while milling, and also providing knob retention.
Features:
Three six-inch steel rollers form two gaps, a preliminary fixed gap of approx .060", and a fully adjustable secondary gap.
Dual eccentric adjusters: 0 to .065" secondary gap - built from STAINLESS STEEL for no galling
8 lbs / minute throughput
3 x 6" hardened steel rollers
Rollers last for 12,000 - 15,000 lbs of grain
Drill-drive - CW, OR CCW
Alloy frame
SAE 841 oil impregnated bronze bushings
1.5" diameter steel rollers
3/8" integral drive shaft w/3 flats for drill driving, 2" long outside frame
1144 alloy steel rollers